"yes, Ahmed Rehan rightly pointed out that your ESC ground might not connected directly to battery. ESC getting ground connection with battery via balance charger >> ubec>> apm>> esc speed controller ground wire >> esc. Yes, check your T-Connectors"
"Hi, i m not getting C/R values on minimosd and all other values are showing properly. C/R values are showing properly in Mission Planner. i am using 2.1.5 r463. "
"Hello, my battery volages are shown different in minmosd-extra as compared to mission planner.
if mission planner is showing 12.4v , the minimosd will show around 10.3. this is the problem.. any solution?
thanks"
"Hello,
If 433mhz Ground Modules are affected by noise from FTDI /USB chips and needs some distance between them. this also means the air modules will be affected by presence of any FTDI chip inside the plane electronics. any thoughts ??
thanks"
"i have similar problem. motor dont arm.. but only when board is powered through USB. interestingly, what i have noticed is that motor will arm when i disconnect gps. any solutions, thanks??"