Gender
Male
About
Please tell us a bit about your UAV interest
RC PLANES UAV..OPEN SOURCE, ARDUPLANE,MPNG,FPV
Hometown:
Cross Roads
Activity Feed
"yes, Ahmed Rehan rightly pointed out that your ESC ground might not connected directly to battery. ESC getting ground connection with battery via balance charger >> ubec>> apm>> esc speed controller ground wire >> esc. Yes, check your T-Connectors"
"excellent..."
"Do arduplaneNG provide Camera Triggering and do_set_servo functionality ? thanks "
"Hi, i m not getting C/R values on minimosd and all other values are showing properly. C/R values are showing properly in Mission Planner. i am using 2.1.5 r463. "
"Hi garbor,
is it possible to decrease the size of fonts on screen.. thanks"
is it possible to decrease the size of fonts on screen.. thanks"
"Waooo. amazing plane.. great work.. keep it up"
"Hello, my battery volages are shown different in minmosd-extra as compared to mission planner.
if mission planner is showing 12.4v , the minimosd will show around 10.3. this is the problem.. any solution?
thanks"
if mission planner is showing 12.4v , the minimosd will show around 10.3. this is the problem.. any solution?
thanks"
"@ Byron, i am getting similar values with 433mhz telemetry module.realy looking forward for your field test results. thanks"
"Hello,
If 433mhz Ground Modules are affected by noise from FTDI /USB chips and needs some distance between them. this also means the air modules will be affected by presence of any FTDI chip inside the plane electronics. any thoughts ??
thanks"
If 433mhz Ground Modules are affected by noise from FTDI /USB chips and needs some distance between them. this also means the air modules will be affected by presence of any FTDI chip inside the plane electronics. any thoughts ??
thanks"
"thanks Michael Obrone"
"i have similar problem. motor dont arm.. but only when board is powered through USB. interestingly, what i have noticed is that motor will arm when i disconnect gps. any solutions, thanks??"
