Gender
Male
About
Location
Southampton
About Me:
Electronics Engineer - enjoy RC Helis and multirotor aircraft
Please tell us a bit about your UAV interest
Built 2 quads with KK controllers for Aerial Video and fun. Looking to build tricopter and hexcopter with ardu pilot
Hometown:
Southampton
Activity Feed
"I guess I must be the only one out there trying to fit quadcopter firmware onto a APM v1 1280? Wish I knew what sections of code I could cut out to make it fit on to 1280 memory"
"Hello.
I am up to speed using ARDUINO programmer console and understand I need the arducopter folder and libraries folder under arduino however I need a Arducopter version that will fit onto 1280.
Can anyone let me know what version arducopter I…"
I am up to speed using ARDUINO programmer console and understand I need the arducopter folder and libraries folder under arduino however I need a Arducopter version that will fit onto 1280.
Can anyone let me know what version arducopter I…"
Hi recently I sold a APM v1 with 1280 memory the bloke I sold it to says you cannot upload the quad firmware to it using the mission planner - it says FIRMWARE IS TOO BIG FOR 1280 PLEASE UPGRADE HARDWAREany ideas to a quick fix? Will the Mission…
"is there a really easy step by step guide to install quadcopter firmware to ArduPilotMegaV1 128k version.??? I am helping out a fellow flyer find a solution for this board but it says 'Firmware is too big for 1280 please upgrade harware'. Any…"
Hi dudes - finally finished a camera ship I have been working on with a friend.ArduPilotMega controller on Home Design Quad with 2 axis camera gimbal. Go Pro camera. I can't wait to take the 'rig' to some scenic places to get some cool…
Hi dudes. Is there any tilt roll stabilisation on APM for Arducopter? Haven't had time to search the forum hence this post. I've recently built a quad and all running fine with APM now its time to hang the GoPro camera. Thanks Gav
"Hope to attend with my gaggle of quads. Hope the weather is better this time :)"
"Ah haaaa just realised I needed to set PARA CH5-SW>E and CH7-SW>A. Under the PARAMETR menu page 2. this was where I was going wrong. "
