Gender
Male
About
Location
Sunnyvale, CA
Please tell us a bit about your UAV interest
Hexacopters
Hometown:
Sunnyvale
Activity Feed
"So that means there's 3 of us then! Guess I'm in good company... :-|
I've been browsing around in the code and -where I certainly do not understand every line- I got the impression that the error-count increases when no update from the GPS is seen…"
I've been browsing around in the code and -where I certainly do not understand every line- I got the impression that the error-count increases when no update from the GPS is seen…"
"Hi DG,
I too see "missing" datapoints in the KMZ file. See attached picture. They do not seem to be at the regular intervals you see them though, which could explain why your INAVErr seems to climb to 255 (the max) faster than mine (?).
Hans."
I too see "missing" datapoints in the KMZ file. See attached picture. They do not seem to be at the regular intervals you see them though, which could explain why your INAVErr seems to climb to 255 (the max) faster than mine (?).
Hans."
"I found I have the same problem! Running a Pixhawk with 3.2 and a CSGShip Neo-M8N GPS. In all my logs, INAVErr climbs to 255, sometimes very quickly, sometimes in steps. I checked for correlation with any other parameters but haven't been able to…"
"Though I didn't get much response on my post, I thought I'd update with the resolution to my problem to go into the eternal Internet logs... :-)
So I contacted 3DR for help. They asked me to send in the unit and replaced it with a new one.…"
So I contacted 3DR for help. They asked me to send in the unit and replaced it with a new one.…"
"Got my external LED from 3D-Robotics today. Doesn't work... :-(
I think my I2C port on the PixHawk is defective. It seems to be the only remaining possibility, unless there would be something wrong with the I2C driver.
I'm surprised nobody has any…"
I think my I2C port on the PixHawk is defective. It seems to be the only remaining possibility, unless there would be something wrong with the I2C driver.
I'm surprised nobody has any…"
"Flashed the Pixhawk board firmware today, together with the just released ArduCopter 3.2 as well as an update to the Mission Planner software. Unfortunately, my external compass still doesn't get detected.
Does nobody have any ideas here? Really…"
Does nobody have any ideas here? Really…"
I'm running a Pixhawk with 3.2 rc14 but cannot get my external compass to be registered/used. I tried two different compasses (one 3DR GPS combo v1.2 and one CSG M8N GPS combo) but neither of these get recognized where the GPS works fine. The…
"I share this question. Anyone?
-Hans"
-Hans"
