Location
Portola Valley, CA
About
About Me:
Software guy
Please tell us a bit about your UAV interest
Easystar APM
Activity Feed
Just curious how it was determined that >3000 would be the right value to expect from the airspeed sensor to indicate that it's connected. I have a APM 1.0 running 2.12 and MPXV7002DP sensor, and after trying 4 different BECs, I can only achieve an…
"So it turns out that the value that's getting read off is too low. Depending on what kind of BEC I use, I can get values ranging from 2940 on higher. I just have to lower the 3000 value that's being used now to determine if it's connected."
I just purchased a MPXV7002DP airspeed sensor, and it's not being detected. Is there a way to determine if the sensor is any good? My setup:APM 1.0 running 2.12uBlox GPSMPXV7002DPXBee PRO 900
"Yeah, I should have included that. Anyways, I added a link to the ublox module I have, it's this:
http://www.sparkfun.com/commerce/product_info.php?products_id=8889"
http://www.sparkfun.com/commerce/product_info.php?products_id=8889"
Hello all,I've built a daughter board and now I'm at the point of connecting the ublox to it, but looking at the ublox, I can't seem to find any pins/leads to connect it to the daughter board. Can anyone who's using the ublox send me a pic of their…
