sent command from MP to guided mode to a specific point and descent to 5M, well it went to the guided point but it kep descending well below 5M until it hit a low fence...I have looked at the logs and you can tell the desired ALT and actual ALT dont
Read more…log file attached.....running AC3.3.1 on Pix, was in loiter then guided mode just hovering at 5m for a while, all good, then sent the land command thru GCS and it just accelerated wildly to the right eventually ramming into my car and then into the g
Read more…have the latest MP beta installed, its strange on the status window it will only show the GPS2 stats if directly USB connected, when I connect over 3DR radio it doesnt show them at all, just zeros....is this a known bug?
Read more…So routine AUTO flight today, all the sudden right before making a 180 yaw turn it goes crazy leaning forward almost full throttle, stops, jerks around some , does it again, I did an RTL and still no good, it went full forward/throttle again, I trie
Read more…hi, since about two ot three beta releases ago I noticed that a lot of the full parameter list descriptions have gone missing completely, which were previously there....some of there are (not inclusive of all that are missing)
ATC_ACCEL_P_MAX |
ATC_ACCEL |
experiencing a consistent issue with AC3.2.1 in AUTO mode where the desired yaw is always 5-10 degrees of from the actual yaw when flying on a straight line, so when filming it never points straight ahead. I know its not the wind because regardless o
Read more…my AC3.2.1 copter yaws into the wind when in forward flight and a crosswind, which is normal I suppose...but the problem is then the camera gimbal is not facing straight forward in direction of travel!! I need to film straight roads and this is not l
Read more…Hi,
I have had about 20 flights or so on AC3.3rc7 on Pix....I usually fly an AUTO mission and I manually takeoff (even thou I have a TAKEOFF entry of 10m) and then switched to AUTO at a low altitude and then it takes it from there, been doing this for
Read more…just what it says, I have GPS glitch set to AltHold...so was in AUTO mission and it hit a GPS glitch....then you see the LAND command go off....even thou I have AltHold set???
come on...what the heck is this? I completely lost confidence on AC now....
Read more…Running pix 3.2.1 on a hexa, whenever it flies upwind (headwind) it bobbles up and down a lot on the pitch, tends to get worse with the stronger the wind is..not sure why...have run autotune and stuff like that otherwise it flies perfect....CG is on
Read more…i was getting 12 sats on my 6H and swapped it for a N8M and what a difference, the N8M picks up 18-20 sats pretty much all the time, loiter is rock solid more than ever.....no problems at all was plug and play to my APM 2.7 with FW 3.1.5....did this
Read more…my Tarot 680 hexa crashed on a flyaway, i was descending then suddenly it started yawing right on its own at a constant rate....I tried RTL twice, no response...I tried to bring it back under STABILIZE...no control response, no throttle response...it
Read more…OK so we all know what happens during an AUTO mode mission if GPS fails for more than 5 sec., GPS_GLITCH triggers and if GPS_FS_ENABLE is true then it will either LAND or ALTHOLD based on its configured setting......all good.
BUT what happens if GPS_F
well strangely enough my hexa (with APM 2.7 and 3.2.1 firmware) got "stuck" at waypoint 4 position, after arriving at it, until I switched to Stabilize mode....no apparent reason, no GPS failsafe or glitch (HDOP was 1.8 all along). logs reveal nothi
Read more…AC3.1.5 - I was in auto mission then suddenly got GPS_FAILSAFE which in my setting sent it to ALT_HOLD....but after GPS recovered (10sec later or so) it didnt seem to return to AUTO mode to continue mission....is this the proper behavior? I took ove
Read more…my quad (APM 3.1.5) does this oscillating altitude hunting during forward auto flights....there is no such problem on AltHold or Loiter modes thou, steady as a rock.....only does this in forward flight.....anyone got any ideas or where to start looki
Read more…started getting these recently, not sure what does it mean exactly, that the quad doesnt have enough climb power all the sudden?
Read more…need some help, my 650 quad is doing this strange surge climbs during AtHold and Loiter modes, I have checked vibrations and the APM is sitting on comfy foam pads.....this is a new build.....
any ideas please? I have attached a zip file containing all
Read more…