Gender
Male
About
Please tell us a bit about your UAV interest
UAV is the future
Hometown:
Haiku
Activity Feed
I have a 3dr quad frame that I added longer arms to account for the 12" props and dji e600 motors I upgraded and I just have not been happy with its performance. Looking for a frame that is symmetrical and can hold the pixhawk, power dist board,…
"I am not sure what you are flying but unless you bought it ready to fly you have to adjust values P,I,D values which can be a bit nerve racking. Curious to hear if there is a performance difference with the ppm encoder and I am just lucky with my…"
"I really doubt it has to do with the satellite but possibly there is interference with it do to placement to close to other electronics. My bet is that it is a tuning issue where you need to adjust throttle and other parameters for your quad so it…"
"Problem solved by going under intitial setup
3dr radio
then loading settings with uav powered and telemetry connected
then I had to fix the "link settings" which did not match my the right settings"
3dr radio
then loading settings with uav powered and telemetry connected
then I had to fix the "link settings" which did not match my the right settings"
Had no problems with 2.0.14 and can connect via the usb port without problems as well. Not sure why the new release is causing problems.Any suggestions?
"I use the DX8 transmitter and cannot answer for the Dx7s and its ability to only use the satellite. This might not work the same.
If your DX7s is bound correctly to the AR8000 and working correctly with it. Then all you should have to do it plug…"
If your DX7s is bound correctly to the AR8000 and working correctly with it. Then all you should have to do it plug…"
Anyone have longer arms they have used for the 2014 diy 3dr frame. These dji 12" props will be to big and that is what I will be required to use with the motors I have(e600). Hoping someone designed some newer arms that also have more screws hole…
"The escs beep when I start every second or 2. This press and hold safety button and they beep faster. Motors do not spin"
I have been reading you do not need to calibrate dji opto escs and after installing cannot get them to work properly.I am trying e600 escs which plug directly into the power distribution board.I did try to do a calibration after it failed to work…
"Yes it says armed on the HUD. I also need the compass and accelerometer calibrations just in case and still no luck. It makes all the noises to initiate like it will work and as soon as I give throttle nothing happens."
"Been flying on 3.1.5 with no problems. Wanted to try follow me so I am trying 3.2 and cannot seem to get my quad in the air.Should I need to recalibrate my escs? I have tried multiple times unsuccessfully. I can get pixhawk to arm but motors will…"
"Did this work well for extending range? My stock antenna is losing signal out at around 300 ft if I am lucky... Any other recommendations on ready made antennas for 3dr telelmetry 915 mhz?…"
