Gender
Male
About
Location
TAS
Please tell us a bit about your UAV interest
Octo
Hometown:
Tas
Activity Feed
"ALternatively, is it possible to power it via USB?
:/
Looking grim!"
:/
Looking grim!"
Hi All,I was hoping someone could assist with some of the issues I have been having!I purchased a PixHawk FC second hand, and when connecting just the FC to the PC, and running MissionPlanner, it made the normal arming sound, however at the end of…
"Thanks Craig, unfortunately the vendor no longer exists :("
"Power from the PM port on the PixHawk does nothing. I have tried an alternate USB caable & PC for that matter... Same behaviour :("
"Thanks Craig, that worked, however somehow my Pixhawk no longer is able to connect to Mission Control? It basically 'clicks' very quietly, and the following lights flicker very quickly: PMU PWR, IO PWR, IO B/E & IO ACT?
I tried flashing it again as…"
I tried flashing it again as…"
"Hmmm, what version of Mission Planner is that? I don't get those frame types, just the quads..... "
"Yes I am! "
"Sorry, one extra query, when I say the Octa+ frame type isn't visible, nor is any other octa of hex frame type, only tri's & quads....
Craig said:
Correct :) it defaults to X"
Craig said:
Correct :) it defaults to X"
"Thanks Craig, greatly appreciate the assistance. I will give it a go when I get home this arvo!"
"Argh OK, so the fact that under "Mandatory hardware" > "Frame Type" the Octa+ isn't visible doesn't matter? Do I just not select a frame type at all?"
"Sorry Craig, I am not being clear....
After I install the Octa + firmware, it then prompts me under the Wizard to select a frame type again, however only offers the following frames to choose from:
Quad x
Quad +
Y6B
Dead Cat
Quad H
There are no…"
After I install the Octa + firmware, it then prompts me under the Wizard to select a frame type again, however only offers the following frames to choose from:
Quad x
Quad +
Y6B
Dead Cat
Quad H
There are no…"
"Hi Craig,
Thanks for the quick response. I should have included that I had flashed the Octa + firmware (I did it 3 times to be sure), and the problem persists.
The only reason I mentioned the quad x part was that I thought there was something I…"
Thanks for the quick response. I should have included that I had flashed the Octa + firmware (I did it 3 times to be sure), and the problem persists.
The only reason I mentioned the quad x part was that I thought there was something I…"
Hi All,I am trying to move to an Octa + configuration using a Pixhawk previously configured to fly a Quad x type config. I have selected the Octa + frame type under the initial setup, it then loads to (supposed) correct config. It then prompts me…
