Gender
Male
About
Location
Niteroi, RJ
About Me:
Systems architecture fan.
Please tell us a bit about your UAV interest
To be able to register every place went.
Hometown:
Niteroi
Activity Feed
Hi all,I have a prolem that my APM2 board is in a hidden location inside my plane and I cannot see the status leds, specially the GPS Fix led.I was wondering if it is possible to connect an external led to one of the APM2 interfaces/outputs in order…
Hi all,I am trying to setup voltage measurement on my ArduPilot Mega / Shield board.However I am really confused about the resistor I have to install.On the manual it says that I have to solder a 3.9K resistor for each cell I want to measure.Since I…
Hello,I am trying to download the MPDatalog utility but I am getting the message:"Your client does not have permission to get URL /p/ardupilot-mega/w/edit/MPDatalog from this server."How can I download it?Thank you,Jaime
Hello all,I am wondering... what is the minimum voltage required for the arduino mega?I am trying to install on a 2S plane, but I am afraid of a general failure due to low voltage.Thank you
Hello,My Mediatek GPS does not get a lock.The blue led blinks slowly continuously. However, I don't think it's a voltage problem, since the voltage on the first pin of the module is 4.7, which I think is ok.I have also tried to remove the battery,…
"Could anyone tell me if there is any chance of recovering my ardupilot mega, and if it appears from the behavior described above that the IMU Shield seems to be ok?
Thank you"
Thank you"
Hello all,This morning, I finished soldering my Ardupilot Mega and the IMU Shield.After a visual check up, I connect the IMU to the computer through the USB connector and a few leds went on both on the IMU and on the ardupilot.The computer…
I am planning to build an autopilot, but the IMU is out of stock. If I get the ArduPilot Mega with the GPS without IMU, can I use it to at least log the path flown and control camera panning servos?
