Hi, I have a problem that when i switch to Stabilize mode, my glider is ok for a few seconds, then goes out of control.I.e. it starts to bank heavily, flaps about and dives for the ground. I have avoided a crash by flicking back to manual to gain…
"Hi Tridge,
I was asked to make you aware of a problem with APM:Plane v3.0.3
Basically i could not get ANY Mavlink data to my MinimOSD from my PX4.
The only way to get it to work was to downgrade to v3.0.1 where upon it worked straight away.
"Ok - after many hours of playing around with MinimOSD and MinimOSD Extra versions and
trying every conceivable combination/settings of the SR1 parameters
I have been able to get Mavlink data from the Serial1 port to my PX4 and it works!
"Ok - after many hours of playing around with MinimOSD and MinimOSD Extra versions and
trying every conceivable combination/settings of the SR1 parameters
I have been able to get Mavlink data from the Serial1 port to my PX4 and it works!
"Hi Miguel,
Sorry for posting here but i didn't know where to post my problem in this thread.
I have recently upgraded from an APM2.0 to a Pixhawk PX4. Everything works fineexcept i cannot get any Mavlink data into the Minimosd
My Setup:
Mission…"
"Ok i have used the 2.4.0.1 r788 CT and loaded up MinimOSD_2.4.0.1.mcm
and MinimOSD-Extra_Plane_Pre-release_2.4_r719.hex (as it's the latest one i could find).
The SR1 params look like this:
Serial 1 is also set to 57
I have recently upgraded from an APM2.0 to a Pixhawk PX4. Everything works fineexcept i cannot get any Mavlink data into the MinimosdMy Setup:Mission Planner v1.3.5 build 1.1.5260.33055APMPlane FW v3.0.3Pixhawk PX4 (3DR)Minimosd 2.1 FW.…
I have recently upgraded from an APM2.0 to a Pixhawk PX4. Everything works fineexcept i cannot get any Mavlink data into the MinimosdMy Setup:Mission Planner v1.3.5 build 1.1.5260.33055APMPlane FW v3.0.3Pixhawk PX4 (3DR)Minimosd 2.1 FW.…