Gender
Male
About
Location
Laval
Please tell us a bit about your UAV interest
Arducopter
Activity Feed
"This must include a service contract and formation etc..."
"@aspenlife
I tried my new Fatshark 5.8G setup today. I'm using the integrated Fatshark 5.8G RX module, the Immersion 600mW TX and stock antennas. It's the first time I fly FPV so I didn't try to find the range limit but I can tell you that I got…"
I tried my new Fatshark 5.8G setup today. I'm using the integrated Fatshark 5.8G RX module, the Immersion 600mW TX and stock antennas. It's the first time I fly FPV so I didn't try to find the range limit but I can tell you that I got…"
"I should get my FatShark 5.8G system with the immersion 600mW transmitter by the end of the week or early next week. From what I read, I'm not expecting more than 300m in good conditions. I don't understand why they make a 100mW transmitter in the…"
"If you are using standard 3DR or JDrones ESCs and motors, you can't use a 6-cell battery pack. The voltage would be out of specs. Use 3 cells or 4 cells battery packs only."
"From which ESC your APM is getting it's power?
If your APM is powered my the BEC of your rear ESC, you might have the same problem I had.
I had a similar problem where after a 10-15min of flight the ESC that was powering my APM, receiver and…"
If your APM is powered my the BEC of your rear ESC, you might have the same problem I had.
I had a similar problem where after a 10-15min of flight the ESC that was powering my APM, receiver and…"
"The red and blacks wires are +5V and grounds. The APM takes its power from this +5V and all the +5V pins of the APM are connected together. If you connect red and black wires from all ESCs you are shorting the their +5V outputs together (trough…"
