"But where in SA can i find a complete 3dr pixhawk kit ?"

"does anyone know how i can get the low voltage cutoff parameter, i'm using an rc timer 40 am esc,i'm esperate please if i have to reflash to ifferent firmware please can anyone tell me which firmware ? i'm currently running 14.6 version firmware an…"

"sr"

"Thank you sounds very viable, last question do you know of a way to recharge the fight batteries on board, by using say a small generator or something else ?"

"Thank you for the suggestion i will go look into that, just want to confirm you say 1c so if the capacity of the geb battery is say 16000 mah, i cannot draw moer than 16 amps from it ? Preferably rechargebles as i'm planning to fly it frequently "

"3-4 hours or so i know it's along shot for an electirc motor setup, but there has to be a way ?"

"Thanks Josh, i'm looking for endurance, am busy sorting out the telemetry and i think i'll get that part going (if all goes as planned so holding thumbs), the biggest obstace would be endurance, for a plane that will weigh's between 12-15kg all up…"

"the vibration parameter read ud-22 ud-15 ud-12, ud-11, ud-6 on higher vibration levels does that mean something ?"

"Can a motor shut down due to excessive vibration ? biggest i have gotten is 38 on shake but that is not when the motor failed, i had 1 shake of a value of 34 while it was failing or close to when it failed if i read the data correctly ?"

"Please can anyone perhaps read this file from the gemini black box and intepret what they see wrong ? This was the last minute of the flight and the motor failure happened between 10-20 meters after coming in for a landing.

I tried to read it…"