Gender
Male
About
Location
Karnataka
About Me:
Aerospace engineer
Please tell us a bit about your UAV interest
Started making fixed wing models and doing RC Flying...want to upgrade with an autopilot
Hometown:
Bangalore
Activity Feed
"Dear Martin,
I had my first flight yesterday with pixhawk integrated. To my surprise we had a nice flight without any issues. I could try out almost all the modes (Stabilize, FBWA,FBWB, Loiter, Auto etc.). It was absolutely fine, had to do little…"
I had my first flight yesterday with pixhawk integrated. To my surprise we had a nice flight without any issues. I could try out almost all the modes (Stabilize, FBWA,FBWB, Loiter, Auto etc.). It was absolutely fine, had to do little…"
"Dear Martin,
Thank you very much for the reply. I will get back to you after my flight...
Thank you
Madhuraj"
Thank you very much for the reply. I will get back to you after my flight...
Thank you
Madhuraj"
"This is the switch port you can see at the centre of the Pixhawk. I is the between the telemetry and serial ports,
thanks
Madhuraj"
thanks
Madhuraj"
"Dear Martin,
At last I got a PPM encoder and it started working now. But only on one condition, after each power on I have to press the Pixhawk reset switch for some time!!!! Then its start working. Do you suspect any firmware issues????
Thank you…"
At last I got a PPM encoder and it started working now. But only on one condition, after each power on I have to press the Pixhawk reset switch for some time!!!! Then its start working. Do you suspect any firmware issues????
Thank you…"
"Hi Martin,
As suggested I have already placed an order for the PPM encoder, I think it may take a while for me to get it..I have ordered the one from 3dr stores, hope it will work.. Will update you once I get it
Thanks for your help,
Madhuraj"
As suggested I have already placed an order for the PPM encoder, I think it may take a while for me to get it..I have ordered the one from 3dr stores, hope it will work.. Will update you once I get it
Thanks for your help,
Madhuraj"
"Hi Martin,
Please have a look at my circuit. I am using an ESC to supply my servo output rail and it is getting power. But as mentioned before, the signal out from pixhawk is the culprit!And also the RC calibration figures are around 1100 ....1900.…"
Please have a look at my circuit. I am using an ESC to supply my servo output rail and it is getting power. But as mentioned before, the signal out from pixhawk is the culprit!And also the RC calibration figures are around 1100 ....1900.…"
"Thank you Martin and Jerome for your kind replies!
I tried the same, but still its not working. After connecting an ESC as you suggested I can see that servo rail is getting power ( This is confirmed with the help of a multi meter and also I can see…"
I tried the same, but still its not working. After connecting an ESC as you suggested I can see that servo rail is getting power ( This is confirmed with the help of a multi meter and also I can see…"
"Hi Jerome,
I have the same issue. Could you please elaborate how can I connect another supply to the output to resolve this issue. Will you be able to share a snapshot of your circuit?
thank you in advance
Madhuraj"
I have the same issue. Could you please elaborate how can I connect another supply to the output to resolve this issue. Will you be able to share a snapshot of your circuit?
thank you in advance
Madhuraj"
