Gender
Male
About
About Me:
Anything that flys enthusiast.
Please tell us a bit about your UAV interest
As above. Open source is king.
Hometown:
Yamba
Activity Feed
So I bit the bullet and bought a Chinese USB / manual controller for my new 4 axis CNC foam cutter to save time. It's a TC5540H, like this:Trouble is I can't make it actually do anything. It powers up and configures OK but doesn't make any stepper…
"I tried this too. As per some info from here:
https://www.hackster.io/phantom-phreak-7ccfe4/extend-3dr-solo-acces...
I hooked up tilt on the Tarot to pin 14 (PWM 6) and set the correct parameters in Mission Planner but never had any joy with the…"
https://www.hackster.io/phantom-phreak-7ccfe4/extend-3dr-solo-acces...
I hooked up tilt on the Tarot to pin 14 (PWM 6) and set the correct parameters in Mission Planner but never had any joy with the…"
