About

Location

San Marcos, CA


Please tell us a bit about your UAV interest

Aerial photography.


Hometown:

San Marcos


Activity Feed

Matt Gieselman left a comment for Matt Gieselman
"Paul I forget exactly how but I think this PDF will get you there.http://4props.ddns.net/quad/v3pdf.pdf"
Feb 1, 2016
Matt Gieselman commented on Hank Danico's blog post Spectrum DX9 2 Switches 1 TX channel 6 Flight Modes
"The DX-9 has a Flight Mode setup menu that lets you combine two switches to support up to 9 Flight Modes."
Jan 10, 2015
Matt Gieselman posted a discussion
I have a Skyhunter which has ailerons and elevator but no rudder, I've searched and read the wiki but I can't find any changes I have to make for the arduplane 3.2 firmware.Can anyone confirm no change are necessary or tell me what changes to make?
Dec 25, 2014
Matt Gieselman replied to Randy's discussion ArduCopter-3.2 beta testing
"To answer my own question doing an ESC calibration appears to have resolved the issue, at least in the garage.

The props also now spin on arm which also wasn't working until the ESC calibration."
Nov 23, 2014
Matt Gieselman replied to Randy's discussion ArduCopter-3.2 beta testing
"Using IRIS+ factory transmitter and receiver 3.2rc14 worked great, I wanted to switch to my DX9 and spektrum satellite receiver.  Now the IRIS+ hunts and doesn't hover, I constantly have to change throttle in stability mode.  It also begins to climb…"
Nov 23, 2014
Matt Gieselman replied to Craig Elder's discussion APM Copter 2.9.1.b has been released
"When I upgraded to rc3 I did a reset, compassmot and accel calibration now ARMING_CHECK is preventing my hexa from arming?

With ARMING_CHECK set to 0 it will arm and appears to fly okay.

The docs say the following are checked "receiver,…"
May 25, 2013
Matt Gieselman replied to Craig Elder's discussion APM Copter 2.9.1.b has been released
"Has anyone used copper mesh shielding under the APM to help reduce EMI with the compass?  Maybe a better question is the magnetic interference caused by the power distribution board (bottom plate on the DJI F550) or caused by the APM being in the…"
May 23, 2013