Gender
Male
About
Please tell us a bit about your UAV interest
Pixhawk
Hometown:
Iowa
Activity Feed
I have installed my Pixhawk in my Nitro/Glow powered plane. I have all the control surfaces working correctly. I have a few questions when it comes to throttle control. I would like to have manual control of my throttle at all times. I have…
"I took a look at the mission planner .tlog today vs the .log on the Pixhawk. Right before the flyoff/crash on the HUD the message "BAD AHRS" appeared. Once that message came up the copter lost control and crashed. With that information can I look…"
"All the ESC's and motors are working. I have put them on another frame and they spin up fine.
Is was borderline too windy to fly, but I have flown in higher winds.
It may be as simple as the 3DR radio antenna (I have an extended one) come in…"
Is was borderline too windy to fly, but I have flown in higher winds.
It may be as simple as the 3DR radio antenna (I have an extended one) come in…"
Today I went out to do some crop surveying with my Pixhawk powered quadcopter. I was in the middle of a auto survey mission about six minutes in the copter went down. I don't know why. The frame is shot but all the electronics are still good. I…
"I just loaded v3.2 rc7 Quad and unable to get my R3008SB to show up in R/C calibration. Are you still able to verify that S-Bus or S-Bus2 works with the R3008SB?"
