Gender
Male
About
Location
Dallas, TX
About Me:
28 yrs r/c 3 yrs all e powered
Please tell us a bit about your UAV interest
research
Hometown:
new orleans, La
Activity Feed
"Update.. this unit was previously installed, but not flown in a quad. Perhaps I need to install Aruduplane again. "
I have a new APM2 flashed for aircraft use and installed.. Mavlink is working. Radio is calibrated and mode switch are recongnized and working, but no apparent output.. no servo movement or esc armed.I have a separate Castle Pro BEC set for 5v,…
"After closer inspection, I realized the plane was in auto.. for some reason my switches were not programed correct.
Its good now but now my servos are glitching... (posting new thread)"
Its good now but now my servos are glitching... (posting new thread)"
Wont airflow over the pressure sensor on the oilpan cause varied readings?..I didnt see it mentioned but it seems logical to protect the unit from airflow.Thoughts?
Using elevon setup with new boards..Controls are working in manual mode and seem to correct/modulate well in stabilize mode, however no matter where the DIPs are set, one axis is always opposite UNTILL I flip the board(s) over with the oil pan…
