APM 2.6 Schematic
Would anyone know if there are Eagle files for the 2.6 board?
I have an intermittent connection on the 3DR connector for some reason and I want to know if I can jumper over to the pads labeled UART2.
Mike
Read more…Michael Walker's Discussions (7)
Sort by
Bad Gyro Health
I have an APM 2.6 that I just built up.
I loaded 3.1.5 on it and went through the wizard. Now, I am seeing Bad Gyro Health and the gyro is tumbling.
In some testing, I loaded 3.0.1 and the gyro issue goes away and the bird is actually flyable.
I've don
Read more…3DR modems connected but won't do mavlink
With an ArduCopter setup, I have:
- a pair of Modems (hextronix ones -- i'm not sure if that is a problem or not)
- Updated the firmware
- Solid green lights
- Exact same settings on both on 433Mhz
- Default settings and latest firmware
- I have connected them both t
APM 2.5 Power Module - incorrect readings
I am using the 2.5 3DR Power module on my APM 2.5 Mega board.
I have reviewed the instructions at http://plane.ardupilot.com/wiki/common-measuring-battery-voltage-and-current-consumption-with-apm/ and from what I can see, this is sort of plug and play
Read more…AdruPlane on EasyStar II
I've jut built up an EasyStar II and did the first test flights tonight.
I did some testing with Loiter which for the most part worked fine. I did a have a funny glitch in the path of the plane while it setup for Loiter. I almost reached for the man
Read more…2.0 board and the APM Power Module
I have the 2.0 board (I think). It was the first of the purple boards with the case.
I'm trying to connect the APM Power module to this module, but I guess it isn't a direct connection as there is no Molex connector for a direct connection.
I'm trying
Read more…Unable to retrieve logs
Hi Guys
I'm pretty new to APM2, so don't be surprised if I missed an obvious step.
However, I set up my APM2 and was able to go for a flight (not without some issues, but at least I got Loiter to work on my ICON A5 while flying off the water).
I want to
Read more…