"Did my measurements of all the parts. Text me tonite...or drop it back during the day tomorrow and after my event around 6pm ill get back with you.
Mike"

"The 322 are the ones for the 650 quad. I was just looking at the build sheet for it last night. There's not much difference in arm length from the 332 using the small plate, and theb275 (?... Let me get home and confirm that size) with the clamp on…"

"You are confusing me. The 650 is not a hex, it's the quad. The hexacopter comes in 3 versions. The first is called the 680 sport, the second is the 680 pro, the third is the fy690. The difference between the sport and pro are the motor mounts. One…"

"Have you gone into the Naza setup utility and mapped your switches for things like RTH, and home/course lock modes, and checked to see if your AETR inputs actually move the corresponding sliders? I had an issue with a new craft, it wouldnt arm, and…"

"Jan...Im thinking that since you are further ahead than me on the DL futaba learning curve, that maybe keeping the 2.4G Tx ON, will let you use a separate 2.4 rx to control additional functions with the LD and RD dials, or the rear scroll wheels,…"

"ps...heres a link with another solution
http://multirotorforums.com/threads/futaba-dual-receiver-question.1...
its along the same lines as my other post"

"Hey. I came across the same question from someone else. You have to go into the 14sg and set it to mode 4 or D, something like that. That enables Sbus for ch 1-8, and let's 9-14 be the regular servo out ports. Do a search for 14sg modes. I think you…"

"Hey. Did you ever get your gear? I have a T680 and it has the SSky 620's on it. I run 12x6 props, and 2 4S5800. I carry a 1000 3S for VTx power and cameras. My AUW is about 5kg, but Ive never weighed it. It flies nice and smooth, and I usually just…"

"Hi Jan. It may have been just before, or after, that I came across a post on another forum about setting the 14SG up on DL. The question there was about turning off the 2.4 RF on the Tx. It was by holding the center of the scroll dial while powering…"

"Hi Ronnie. I just got a DL setup, already with a Taranis, but I will be switching it to my 14SG soon. Both DL and Utoob have descriptions for installing the DL units. Apparently some Futaba radios dont have a power out pin on the trainer port, so…"