Gender
Male
About
Please tell us a bit about your UAV interest
Aerial Photography Platform
Activity Feed
"Reversing my elevator channel (ch2) in the advanced params solved it. Next step is getting the plane in the air! :)"
"Hey Chris,
Thanks for the quick reply. I actually had read that page hoping it would help, unfortunately it shows being able to reverse the channel with checkboxes. I've attached a screenshot of what my APM version looks like. I did though think of…"
Thanks for the quick reply. I actually had read that page hoping it would help, unfortunately it shows being able to reverse the channel with checkboxes. I've attached a screenshot of what my APM version looks like. I did though think of…"
I seem to have an issue with my APM 2.0. First off, I am running ArduPilot v3.0.3 and APM Planner v2.0.9. I have set up the IMU and everything works fine (kinda).I calibrated my remote (HiTec Aurora 9 if it matters) and that works fine. I prefer to…
"Hey Daniel,
I realize this post is rather older (in fact a month to the day), but I was googling the same issue as what you had mentioned. Couldn't find any helpful info, but I think I determined what caused my issue.
I am working on trying to get…"
I realize this post is rather older (in fact a month to the day), but I was googling the same issue as what you had mentioned. Couldn't find any helpful info, but I think I determined what caused my issue.
I am working on trying to get…"
"Randy,
I know I have had the problem where my motor will start on its own and not stop. This is due to me powering the plane before turning on my transmitter. It goes to a failsafe mode, once that happens I can't turn the motor off. I always…"
I know I have had the problem where my motor will start on its own and not stop. This is due to me powering the plane before turning on my transmitter. It goes to a failsafe mode, once that happens I can't turn the motor off. I always…"
I have a question regarding propeller selection. Currently I am using Master Airscrew props.Master Airscrew 10x6My quad is 24" x 24" aluminum tube with Turnigy 2217 16turn 1050kV 23A outboards. 2 motors are powered by a Zippy 5800mAh 30C battery,…
"Andrew,
For CAM software I use PyCAM. While I don't have much experience with the program yet, I have used it a few times to get an idea of how it works. The nice thing is it will pull in 3D models in STL format. This works well for me. I then send…"
For CAM software I use PyCAM. While I don't have much experience with the program yet, I have used it a few times to get an idea of how it works. The nice thing is it will pull in 3D models in STL format. This works well for me. I then send…"
