Gender
Male
About
Location
Vantaa
About Me:
Workiing on drones
Please tell us a bit about your UAV interest
Indoor Autonomous drones
Hometown:
Tampere
Activity Feed
Hi,I am new to pixhawk. I am using pixhawk 2.4.8 . I am getting pressure altitude from the pixhawk. I flew the drone in the open air at almost 5 to 6 meters height. Initially took off the drone with lidar then shift to barometer altitude but huge…
"Yes i am trying to read barometer reading directly from pixhawk by mavlink inspector in QGC. is there any parameters to set to get the correct altitude with the barometer. Right now i am getting -77m Altitude (amsl). It almost seems to stay at this…"
"Could you please let me know if i need to compare the performance of these two Pixhawks. Which parameters do i need to focus on ? Chris Anderson said:
The Pixhawk numbering is confusing, because it's open source and the Chinese manufacturers invent…"
The Pixhawk numbering is confusing, because it's open source and the Chinese manufacturers invent…"
"Do i need to set some parameter to read the barometer altitude? I am getting Pressure_alt around -79 in QGC mavlink inspector. I don't understand what is this. Please let me know what is required to read the correct reading of the barometer from…"
Hi,I am new to pixhawk. I am using pixhawk 2.4.8 and PX4 firmware version 1.5.5. Please let me know, how could i enable PX4FLOW to update the pixhawk local x and y positions. is it just to connect the PX4FLOW (say by I2C) and the lcoal position of…
Hi,I am new to pixhawk. I am using pixhawk cube 2.1. I need to use pixhawk's own barometer to calculate the altitude. Please guide me that how to get readings of the barometer or the baro altitude. I am using PX4 firmware version 1.6.3. In the…
Hello,I am new to pixhawk. Please let me know what is the major difference between between pixhawk 2.1 and pixhawk 2.4.8 on the basis of performence . I know there is redundancy in pixhawk 2.1 as it has more Gyros/accelros etc.
