Gender
Male
About
About Me:
I like to work with electronics.
Please tell us a bit about your UAV interest
UAV is a good fit for an interest in electronics.
Activity Feed
"With the APM 1.0, I was just powering the board, along with the servos, though the inputs from the RC receiver, and that worked just fine. But, those servos were also just the little ones that were on my hawk sky. So, should I run a cable line from…"
"Thank you so much for your very thorough reply. I really do appreciate the help.
I was just wondering because I have a senior telemaster that I'll be using it in, with 4 or 5 of these servos, and just wanted to make sure that they won't overtax…"
I was just wondering because I have a senior telemaster that I'll be using it in, with 4 or 5 of these servos, and just wanted to make sure that they won't overtax…"
"Bump for any helpful comments."
Hi guys, Just wondering about some of the technical specifications for the APM 2.0 board. Do we know what the max current output is per each servo, and the whole servo rail? Just wondering so I don't use servos that draw too much current. Also, I…
"Also, in the command line window in the HK Ground Control Station, I'm only getting a print like every half second. An example line would be -
"MAVlink - 55 03 FC 01 01 00 01 03 02 5E 8C"
"
"MAVlink - 55 03 FC 01 01 00 01 03 02 5E 8C"
"
"Okay, I tried using the APM V1.02 and it worked, so I'm not setting something up right in the code. Any ideas?"
Hi guys, I've been working on this for a while and cannot figure it out. First of all, I am running the ATMEGA1280 board with the APM 2.23 software(tried different versions with no luck). When connecting the APM setup through USB to the computer,…
