Gender
Male
About
About Me:
Drone Addicted
Please tell us a bit about your UAV interest
Fixed wing, multirotors,
Hometown:
Gdynia
Activity Feed
"@laser developer. To be clear.
My intentions is to log readings. Im using i2C and want to log the readings.
Im ussing Devantech i2c as stated and proposed in manual.
Connection is okej, limited commands i2c test are working on terminal.
Im…"
My intentions is to log readings. Im using i2C and want to log the readings.
Im ussing Devantech i2c as stated and proposed in manual.
Connection is okej, limited commands i2c test are working on terminal.
Im…"
"Do the termimal provided by lightware and LW20 software have tge same funcionlity on I2C and Serial laser interface ?
Is it possible to log laser RAW readings, distances, via I2C interface on a PC ?
I need to log two LW20 readings on I2C bus…"
Is it possible to log laser RAW readings, distances, via I2C interface on a PC ?
I need to log two LW20 readings on I2C bus…"
"new log file67 2016-10-31 16-04-14.bin"
"Dead Droners,
I've check everything. Add second GPS. Corrected cabling. Start IMU logging.
On the field I've done compass calibration and motor compass calibration.
No significant changes, unfortunately, still copter very aggressively corrects…"
I've check everything. Add second GPS. Corrected cabling. Start IMU logging.
On the field I've done compass calibration and motor compass calibration.
No significant changes, unfortunately, still copter very aggressively corrects…"
"This problem was indicated and solution patented (patent US 6522291 B1) "GPS receiver sharing an antenna ground plane with an EMI shield"
I thing that a DIY drones community using a cheap GPS equipment/modules not take it into account. Patented…"
I thing that a DIY drones community using a cheap GPS equipment/modules not take it into account. Patented…"
"I've check again all wiring, buzzer and GPS was tied up together. It could be a reason why during arming I've lost a signal. Buzzer was signaling and sth was interfered.
Will see.
Off course log will be full with INS and BARO during next field test."
Will see.
Off course log will be full with INS and BARO during next field test."
"Yes it does, it overpowered
Michael Burmeister said:
You messed with the logging. You are not logging Barometer or Vibrations so hard to determine what's going on. By some of the parameters it looks to be an over powered copter and has a…"
Michael Burmeister said:
You messed with the logging. You are not logging Barometer or Vibrations so hard to determine what's going on. By some of the parameters it looks to be an over powered copter and has a…"
Hi,Dear Droners :)Every thing was OK, copter stays in loiter mode without any problem.After slight modification, added FPV TX, OSD and LC Filters and Gimbal cpter is flaying away in loiter mode. It looks like it change position very aggressively.…
"Odometry is calculated on board quad or on GSC ?"
