About

Please tell us a bit about your UAV interest

DIY Arduino based flight controller


Hometown:

South Africa


Activity Feed

PeeBee replied to Navigant's discussion MINIMOSD STOPS OVERLAYING DATA
"Some cameras are not compatible with the MAX chip on the MinimOSD. perhaps thats your issue?
You could also try a LC filter after the BEC before the OSD."
Apr 26, 2016
PeeBee replied to Navigant's discussion MINIMOSD STOPS OVERLAYING DATA
"I found the video chip on the MinimOSD is very sensitive to voltage. I think anything below 4.9V and it resets itself. I add a big cap on input to the OSD, and never power it off the same 5V as servos, because they cause huge voltage spikes."
Apr 25, 2016
PeeBee commented on Andrew Rabbitt's blog post Introducing HDwing 4 - my motor-glider for high altitude balloon (HAB) launch
"Its been a long time since the last post here... A great looking idea!  What has become of it since?"
Mar 9, 2014
PeeBee commented on Bruce Jones's blog post Getting 6 Modes out of Channel 5 on a Spektrum DX7s
"Just got 12 modes onto one channel!  I will use it for camera tilt, using three switches.

I used the flaps switch, plus F-mode and Elev D/R, with 2 mixes.  Here is the monitor with the 12 positions marked.  I was not as methodical as Bruce - I just…"
Jan 19, 2014
PeeBee commented on Bruce Jones's blog post Getting 6 Modes out of Channel 5 on a Spektrum DX7s
"Thanks for that Bruce.  I was also soooo irritated by the DX7s not having backlighting, and one afternoon I had it open and stuck some in.  Its not hard at all - here is a post about…"
Jan 19, 2014