Gender
Male
About
Location
Kungsbacka
Please tell us a bit about your UAV interest
Interested in copters for filming
Hometown:
Gothenburg Sweden
Activity Feed
How can I get my Pixhawk Rover to arm.All seems to be ok but it will not arm.Suggestions please.
This is my theory:On Basestation only having a M8T Gps and a radiolink to send data to rover.In the rover i have strsvr to feed Basestation data to RTKNAVI.Do you Think this will work?
"Matthew!
What a nice job! awesome.
I have plans to do the same and have ordered parts that is going to be used.
Have you planned to use DIY RTK equipment?
I plan to use Lattepanda with Arduino on the board and install RTKLIB in Lattepanda.
I am not…"
What a nice job! awesome.
I have plans to do the same and have ordered parts that is going to be used.
Have you planned to use DIY RTK equipment?
I plan to use Lattepanda with Arduino on the board and install RTKLIB in Lattepanda.
I am not…"
I am interested to make an affordable RTK solution for my pixhawk.This is my plan:Basestation: Lattipanda with RTKBASE and an NEO m8T GPS.Rover: Lattipanda with RTKROVER and NEO M8T GPS connected to PIXHAWKThe pixhawk is going to be in my tractor…
Have someone tested this? I would like to have telemetry data in my reciever as for my Tali H500 original.Any ideas if this is possible?Have someone tested?
"Yes. reciewer walkera rx705 is a ppm reciewer"
"YES! That was the problem!"
I can upload initial software to my Pixhawk but i can not get in Contact in flight data. I get the message:No heartbeat packets received.Do I need to have a Micro SD-card in the controller?
