"Yes I have used retract landing gear on my HEX. I only use one, that retracts out of way of camera. The other two legs are normal for stability. I tried 2 retracts and legs were too wobbly. It takes two legs at least to be stable.…"
"I have a little progress on problems after loading PPM upgrade.
I did the PPM install again using FLIP3.4.7. Loaded Hex file ArduPPM_v2.3.16_ATMega32U2. Again it shows burned, verified.
I go to Mission planner. I still have the port COM3 show up…"
I tried again today to get past the PPM upgrade. Still does not work and I have no idea of what to try next.I again tried to connect computer to Arducopter with USB port. Photo 001 is the result. Port shows up again but no connect. Anyone know what…
I am having problems connecting mission planner to my APM2.0 after I upgraded my PPM encoder. Trying to move up from ArduCopter V2.9.ib Hexa to V3.0.Mission Planner 1.2.59 mav 1.0 APM2.0 3DR Radio Win7 computer with…
After 2.9.1.b my 3DR Radio 915 does not connect. Also no GPS & ARM leds (top GPS does work). Can not arm with remote. Yet if I am on USB port, the GPS and ARM leds blink. So I wait till GPS lock, plugin battery and disconnect USB, then I can arm…
I just upgraded to ArduCopter 2.5.5 and I am having trouble. Takeoff looks totally eratic. So I started by testing motors using Mission Planner CLI / Setup / Motors. It used to test them starting with front motor and going clockwise testing each…
"I also had trouble setting up the Turnigy 9x v2 Mode2 and its reciever v2 that came with it. (Bought in April 2012) This is how I got everything to work.On the Turnigy 9x v2 Mode2: a) trim your rudder down as far as it will go. b) Reverse the…"