Hi, I have APM 2.5 installed in my Skywalker X8. It is powered by the 3dr power module and the servos are powered by a separate BEC. I am getting servo jitters and jerks in all modes for some reason and cannot seem to isolate the problem... I am usin
Read more…Does anyone know how to completely wipe all the data and firmware from APM 2.5 so that I can start over from a clean slate? I have been having problems and it has worked fine in the past but now it doesn't work.
Read more…I updated MP to .35 and APM to Arduplane 2.70 and now my board is completely not responding to anything. I looked in the discussions at a member that had a similar problem and it was suggested that it was a voltage issue not allowing EEPROM to be rea
Read more…I am using apm 2.5 and minimosd for fpv. I have finally gotten almost everything working so far. My biggest problem right now is the altitude on minimosd. When I don't have my gps connected it works fine, but if I do have GPS connected it displays 84
Read more…Hi, I just read one of Chris's blogs from august about a new version of Mission Planner. It said on there "9. There has been some work done for running the planner on Mac, there are still a few issue however." Does anyone know how this is going or wh
Read more…