Gender
Male
About
Location
Eindhoven
About Me:
Just a flyer .. scale 1:1 and the models
Please tell us a bit about your UAV interest
vliegen.indusolve.nl
Hometown:
Eindhoven
Activity Feed
"I just loaded code 2.0 and try the field setup again. After a few seconds the blue light started to blink rapidly.
Soon I will do the field check.... on the field ... now I did it at home.
After that, I will load the 2.1.1 version again. I think the…"
Soon I will do the field check.... on the field ... now I did it at home.
After that, I will load the 2.1.1 version again. I think the…"
"@ Chris,
ASP 310 thh 0 rll -60 pch -60
when I put my hand over the FMA sensor
I see the change ASP 350
Seems to be right, or .....
Robert"
ASP 310 thh 0 rll -60 pch -60
when I put my hand over the FMA sensor
I see the change ASP 350
Seems to be right, or .....
Robert"
"Problems with the field setup step number 2
Code 2.1.1
all servo are connected
jumper on D6-D7
"The yellow status LED will blink for a few seconds as the autopilot programs the GPS for binary mode. Then the blue lock GPS will blink rapidly, which…"
Code 2.1.1
all servo are connected
jumper on D6-D7
"The yellow status LED will blink for a few seconds as the autopilot programs the GPS for binary mode. Then the blue lock GPS will blink rapidly, which…"
"@Chris Anderson @Gagarien @Reto
Thanks for the very clear explanations. The problem will be solved by using the V2, I was wishing for that . I allready have the extra components to build it. I just used the V1 to learn about the ardupilot. No…"
Thanks for the very clear explanations. The problem will be solved by using the V2, I was wishing for that . I allready have the extra components to build it. I just used the V1 to learn about the ardupilot. No…"
"Problem has been solved , ik works perfectly now.
I set the parameter on "80" in stead of "30"
"if((wp_distance<30)&&(jumplock_wp==0x00))//Checking if the waypoint distance is less than 30, and check if the lock is open""
I set the parameter on "80" in stead of "30"
"if((wp_distance<30)&&(jumplock_wp==0x00))//Checking if the waypoint distance is less than 30, and check if the lock is open""
Hello,Today we had our first testflight with the Xbee and it works perfect (ardupilot 1.0) ! We made a flight of three waypoints and landed after that one to change the batt.However after the first flight the xbee log file shows gps altitude of…
Hello,Since a couple of months I am busy with preparing the ardupilot.ardu version 1,0I made a flightpath of 3 waypoints. When I switched on the autopilot it seems to work fine and it headed to the first waypoint.However when it reaches the first…
"Hi,
I am also a beginner and my ardu doesn't work yet ... but I am learning alot by reading the forums.
This is a nice start.
http://www.ladyada.net/learn/arduino/starterpack.html
FMA
Do you mean the stabilize X,Y ?
It will not altitude hold ,…"
I am also a beginner and my ardu doesn't work yet ... but I am learning alot by reading the forums.
This is a nice start.
http://www.ladyada.net/learn/arduino/starterpack.html
FMA
Do you mean the stabilize X,Y ?
It will not altitude hold ,…"
