Roger Church's Discussions

Roger Church's Discussions (4)

Sort by

high voltage reading in mission planner

Recently I update my Firmware on my apm 2.6 to the newest version. Then I completed the wizard then I went into config/tuning and loaded my parameter files to it.All said and done I went to flight data and it showed extremely high voltage readings(30

Started by Roger Church

Throttle drops off around 35 to 40% then jumps up around 50 % throttle stick position

Using a Apm 2.6 on my quad . As I arm it up and raise the throttle motors spin up . Then at 35 to 40% throttle stick position the motors drop down it rpm then move the stick up more. The motor rpms jump up.

Any suggestion on what to check?

Started by Roger Church

Turnigy 9x roll stick is alittle off center

I'm using a apm 2.6 on my quad and when i arm it. The Number 2 motor doesn't spin fast as the rest,But if I move the roll stick just a little right it spin up fine.Should i use the trim function on the radio or use MP to correct the problem ( not sur

Started by Roger Church

Terminal not working in Mission Planner with a APM 2.6 board

When I try to connect to my apm 2.6 board with terminal in mission planner it shows a bunch of continuous letters numbers and symbols. The specs on the apm 2.6 does say it has the ATMEGA2560 and ATMEGA32U-2 chips

Started by Roger Church

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

high voltage reading in mission planner

Throttle drops off around 35 to 40% then jumps up around 50 % throttle stick position

Turnigy 9x roll stick is alittle off center

Terminal not working in Mission Planner with a APM 2.6 board

Note: this page contains paid content.