( In this case, I would enter "14.13" into the magnetometer line (the Mission Planner software converts that degrees.minutes notation to the proper decimal values internally).HiMy changes always back to "0" ? what am I doing wrong.RegardsTimo
"Hi
I have problem to enter the Degrees in apm planner it change the numbers back to 0 ?
if I print 4.25 it change the self- back to 0 again ? what am I doing wrong I am in "setup" hardware and compass.
I thinks is better to wait for ArduPilot Mega 2.0.
Now I can buy parts for copter and think about how it will be built and read on the subject.
Regards
Timo"
"Hi
I will build a ArduCopter and thinking about buying ArduPilot Mega 2.0 but is out of order now.
Can I use ArduPilot ATmega 2560 1.4 and ArduIMU+ V3 instead of ArduPilot Mega IMU Shield OilPan Rev-H V1.0 ?
Regards
Timo
Sweden"