My Brushed esc getting hot when connected to arducopter board,
But its working smooth with the servo tester and motor run both direction and stops so all fine when tested with servo tester
when esc connected, telemetry module not working, when diconect
Read more…can we control the brushed motors using brused esc such that, if we want to reverse the rover, then can we rotate the parallel motors in opposite direction?
Read more…can we use Ardurover 2.6 with Hbridge to control dc motors?
is there any output to control enable direction and pwm pins from ardurover to control the respective pins of hbridge like l298?
Read more…can we use Ardurover 2.6 with Hbridge to control dc motors?
is there any output to control enable direction and pwm pins from ardurover to control the respective pins of hbridge like l298?
Read more…I like to build Ardurover using arduino mega 2560 board, from where i can get the schematic for pins used for connecting Hbridge, GPS and configuration in the code etc?
Read more…I am newbie to this forum and ardurover, I would like to build Ardurover using arduino mega 2560 board, where can i get that wiki, like the pins to connect the Hbridge, gps etc/
Read more…