About

Gender

Male


Location

Haifa


About Me:

Aeronautical Engineer PPL + INST ASEL


Please tell us a bit about your UAV interest

Completely Autonomous UAS, Based on self-design :-)


Hometown:

Haifa


Activity Feed

Yaacov E posted a discussion
Hi,During the last week I've crashed by RC plane following the addition of new motors (2xPlettenberg), new batteries (4x5S, 5000mAh each) and the Atto Pilot 90A sensor, used as a "fuel meter".Former (and trusted) setup:2xPlettenberg (26 series,…
Apr 12, 2014
Yaacov E posted a discussion in ArduRover User Group
Hi,I've integrated an APM2.6 with 3DR GPS and RFD900 telemetry on a small vehicle.Firmware installed successfully and i tried to navigate in a triangle in a parking lot to see the guidance in action, However each time i turn to AUTO mode and start…
Jan 10, 2014
Yaacov E replied to Yaacov E's discussion Troubleshooting RFD900/3DRadio setup
"OK after googling half the internet i got nowhere:
1. Disconnecting and uninstalling all COM ports except for the telemetry (now set as COM 4)
2. Forced bootloader mode / regular mode - both ineffective
3. 2x RFD900 units, both fail to connect to…"
Nov 19, 2013
Yaacov E posted a discussion
Hi,I'm trying to connect the hardware to the PC (it is not yet connected on the RC side) and i spent a lot of time and i can't get it to connect. Windows 7 (64bit) successfully installed the device, And it got COM12 id.This is the only active port…
Nov 19, 2013
Yaacov E posted a discussion
Hi,I recently got the APM 2.6 and uploaded latest arduplane firmware, Now i'm looking to check all sensors respond well and i can't get an "alt asl" reading. *The APM is connected solely to PC via USB cable, No other stuff.*The "bar pressure" field…
Nov 15, 2013
Yaacov E posted a discussion
Hi,I'm part of a team designing a Canard RC plane and i'ld like to verify a support on APM2.6.The thing is, I don't want to end up after moduling and setup and regret choosing Canard configuration and/or buying APM2.6. I hope my question is clear…
Sep 27, 2013