Hi,
During the last week I've crashed by RC plane following the addition of new motors (2xPlettenberg), new batteries (4x5S, 5000mAh each) and the Atto Pilot 90A sensor, used as a "fuel meter".
Former (and trusted) setup:
2xPlettenberg (26 series, diffe
Read more…Hi,
I've integrated an APM2.6 with 3DR GPS and RFD900 telemetry on a small vehicle.
Firmware installed successfully and i tried to navigate in a triangle in a parking lot to see the guidance in action, However each time i turn to AUTO mode and start th
Read more…Hi,
I'm trying to connect the hardware to the PC (it is not yet connected on the RC side) and i spent a lot of time and i can't get it to connect.
Windows 7 (64bit) successfully installed the device, And it got COM12 id.
This is the only active port at
Read more…Hi,
I recently got the APM 2.6 and uploaded latest arduplane firmware, Now i'm looking to check all sensors respond well and i can't get an "alt asl" reading.
*The APM is connected solely to PC via USB cable, No other stuff.
*The "bar pressure" field i
Read more…Hi,
I'm part of a team designing a Canard RC plane and i'ld like to verify a support on APM2.6.
The thing is, I don't want to end up after moduling and setup and regret choosing Canard configuration and/or buying APM2.6. I hope my question is clear eno
Read more…