About Me:
Just a First time Flying Machine builder
About
Please tell us a bit about your UAV interest
Currently doing a quadcopter for my final year Project
Hometown:
Singapoer
Activity Feed
I'm using APM 2.6 and the today while i was flying my quad, it suddenly flip and crash. After which i tried to connect my APM to MP using USB but it is unsuccessful.The first instance when connecting with USB, i do not even see the red LED blinking…
"Currently I have purchase EasyVR 2.0 ,http://www.veear.eu/products/easyvr/ along with an Arduino UNO board. These two product will be attached to the quadcopter itself and perform the command. If this process works, then I would progress further…"
Currently I'm using a APM running on AC3.2.1 and I have an external Arduino Uno Board that is connected to APM2.6..The Analog output pin 3 of UNO is connected to APM A1 and certain actions I perform, the output pin from UNO contain certain…
I have tried using the Developer code(Version 3.2.1 & 3.3) from Github, and have able to compiled and upload (Using Arduino IDE) them into my APM2.6.However it does not connect to mission planner, I received "No Heartbeat Received". I have enable…
I would like to ask if it is possible to have a voice command such as "take off / landing" and attached it along with APM 2.6 and what are the methods to perform such commands?
Currently I've linked up my Optical Flow sensor with APM 2.6 and i have followed the instruction from the arducopter wiki link. I have ensured my connection for the optical flow sensor based on looking at the Eagles file for APM and connect them…
Good Evening all,Currently, I'm having an apm 2.6 which can be powered normally by USB. However whenever i plugged in pins to (5V & ground) for example RC inputs to the input side of APM, the board will then be automatically turn off.I have measured…
"Just set ur throttle max value to 1000 and it will work accordingly already. No worries"
"Can u check ur full parameter list on mission planner and check ur THR_MAX value? Initially mine was 8 only and i changed it to 1000 and it was running okay already"
I gotten a APM 2.6 board and when it is plugged in via USB to my computer, Mission planner will be able to get all the parameters on the board.However using telemetry via XBEE, I have ensured that both ground and air are set to 57k baud rate and…
