Gender
Male
About
Location
zurich
Activity Feed
"Unfortunately I seem to run into every problem with my prototype.
and the documentation most of the time is not useful.
and I'm not an electronic engineer so talking about pins is beyond me.
and I really doubt that if I put my questions on the forum…"
and the documentation most of the time is not useful.
and I'm not an electronic engineer so talking about pins is beyond me.
and I really doubt that if I put my questions on the forum…"
"unfortunately AR drone is cheaper..."
"if it is a mess there is no point bragging about it.
Lets set the goals we want to achieve than the milestones and get to work."
Lets set the goals we want to achieve than the milestones and get to work."
"Hi Jason,
I would like to help.
I tried to send you a message but it seems you have to let me to add you first as friend.
anyhow.
If you need help let me know.
best regards,
dacian"
I would like to help.
I tried to send you a message but it seems you have to let me to add you first as friend.
anyhow.
If you need help let me know.
best regards,
dacian"
"sorry
here is the link"
here is the link"
"I think I'm going to power it as above and use this to convert the input power
do you think is a good idea?"
do you think is a good idea?"
"I think I got it
you provide power through the connections to the ESC.
I thought you are doing something like below:"
you provide power through the connections to the ESC.
I thought you are doing something like below:"
"and how do you ensure that the power is only 6V.
My battery is a 3cell and outputs 11.1V so I can't connect it to ardu pilot board directly.
Does you battery output 6V?"
My battery is a 3cell and outputs 11.1V so I can't connect it to ardu pilot board directly.
Does you battery output 6V?"
"oh I thought you were using this
I read the documentation and that the connections I see are actually the R/C receiver like in
This is a little puzzeling I always thought the controls are sent through the xbee.
what do you use as R/C receiver?…"
I read the documentation and that the connections I see are actually the R/C receiver like in
This is a little puzzeling I always thought the controls are sent through the xbee.
what do you use as R/C receiver?…"
"hi
I hope you can answer me cause I have two questions.
I'm not into electronics cause I'm a software programmer... so take me slow.
am I wrong or you are using a stabilaser?
if yes could you post a link where you bought it?
Are you using a separate…"
I hope you can answer me cause I have two questions.
I'm not into electronics cause I'm a software programmer... so take me slow.
am I wrong or you are using a stabilaser?
if yes could you post a link where you bought it?
Are you using a separate…"
"hi
what battery do you use to power ardupilot?
If I'm not wrong I see you are using a different battery for the engines as for ardupilot.
Can you give me the link where you bought it?
thanks in advance,
dacian"
what battery do you use to power ardupilot?
If I'm not wrong I see you are using a different battery for the engines as for ardupilot.
Can you give me the link where you bought it?
thanks in advance,
dacian"
"well I guess I'll need to learn another skill: to make pcb-s"
"this happens with everything open source...
you have to dig until your eyes pop out to get it working..."
you have to dig until your eyes pop out to get it working..."
"hi
I have all the boards but I need the power distribution board.
does anyone know where I can buy just that?
thanks for any advice,
dacian"
I have all the boards but I need the power distribution board.
does anyone know where I can buy just that?
thanks for any advice,
dacian"
