About

Gender

Male


Please tell us a bit about your UAV interest

Building a vtail


Hometown:

West sussex


Activity Feed

david replied to david's discussion pixhawk + Raspberry pi Zero w
"Awesome, thanks a ton!"
Feb 7, 2018
david replied to david's discussion pixhawk + Raspberry pi Zero w
"Thanks again fnoop, helpful as always. I don't suppose you have any info on the usb  cable conversion?"
Feb 7, 2018
david replied to david's discussion pixhawk + Raspberry pi Zero w
"Well thanks for that fnoop, anything that can cause a catastrophic failure is obviously not a good idea, do you know if there is an official or advised way to power the pi3? As I'm struggling to catch your drift with powering from bec (as you can…"
Feb 4, 2018
david replied to david's discussion pixhawk + Raspberry pi Zero w
"Fnoop, first time I've heard this, can you explain a little? I've powered a pi3 this way before but didn't know it was a bad idea. Are you able to explain your setup?"
Feb 3, 2018
david replied to david's discussion pixhawk + Raspberry pi Zero w
"So after some research the wiring is the same for rpi3 and zero, has anyone got the zero to work?"
Feb 3, 2018
david posted a discussion
hi guys,trying to set up my rpi zero w with pixhawk as per these insructions: http://ardupilot.org/dev/docs/raspberry-pi-via-mavlink.htmldid a quick test to see if I get power by connecting power via usb to pixhawk ONLY and I don't seem to get…
May 8, 2017
david posted a discussion
Hi guys,I'm building my 1st drone and getting a bit lost when it comes to Motors. My drone currently weighs 900g, it's a 4 motor vtail setup using a 11.1v 3500mAh 25c lipo battery. I made a guess at the battery as I'm totally new to battery powered…
Jul 14, 2016
david replied to Mike's discussion Wire raspberry pi to pixhawk
"Hi there,
im wondering if you have had any luck with your problem? i am also using pi3 + pixhawk (using the above recommended cable with the wires swapped as per the ardupilot guide), serial ports are off. im getting almost the exact same thing as…"
Jul 10, 2016