"It was interference from the camera, but i had to move it a lot farther than a few inches, but thanks fro the info."

"thanks for the reply, but i do not think its noise from the camera. I used another camera and vtx on my quad and put it right next to the gps and it did not affect it at all, but both cameras do the same thing when plugged into the plane. One thing…"

"just going through my setup on the mission planner and when i bound the radio to the rx using the lowest throttle ( 929ms ) i also had the flight mode switch in manual mode. Do i need to bind it in stabilize or auto mode for the rth to work…"

"thanks for the informative reply. I am going to switch my apm2 to a f450 frame and work on tuning. i will have to use another board for my fpv, thanks again for the reply."

"stabilize mode is not how i am used to flying, i currently fly a naza on my other quad and i fly in manual ( acro ) mode, its alot more like flying my helis. Flying in stabilize mode is boring for fpv, i like to do loops and rolls and fly around…"

"i probably tried it about 50 times and it never armed one of them. hopefully i will get my new dji opto esc's and dont have any problems. "

"ok i just plugged the apm2 into my dji 30amp opto speed controls and they arm just fine."

"Thanks for the reply eddie, i plugged a servo into output 5 and it moves along with my throttle stick ( it is kind of notchy, and jumps to zero around 15% throttle ). I tried to do the auto calibration and the apm2 is outputting the signal correctly…"