Hi everybody
I'm testing this script with an old !ixus 70.
The CHDK runs perfectly, interval.bas is OK.
When I run The 3DR_shoot on board, connected to the APM, with a Gentle USB2 wire, after few seconds, i have error messages. Nothing happens if it is
Read more…Hi everybody
I'm testing this script with an old !ixus 70.
The CHDK runs perfectly, interval.bas is OK.
When I run The 3DR_shoot on board, connected to the APM, with a Gentle USB2 wire, after few seconds, i have error messages. Nothing happens if it is
Read more…Hi,
The day before yesterday, the weather condition were ideal for testing the autotune as I updated the firmware to 3.1.1.
After the flight, back to my workshop, I left the quad on a table behind me.
In order to see the new PID, I didn't switch off th
Read more…Hi,
I just updated the usb module with MP without any problem, the firmware version is now the 1.9.
I tried to update the air module (firmware 1.6) with both FTDI cable 3.3V and 5V . Impossible to connect.
What is wrong? The com port is the right com po
Read more…Hi
After 15 to 30 seconds, the flight data disappear from the screen. Any idea why?
Thanks
Read more…Hi
My target is to take a picture at a WP (camera Canon with CHDK)
When you generate a grid (MP 2.95) inside a polygon with many waypoint it 's really slow to add manually a DO_SET_SERVO after each WP. I generate 60 to 200 WP....
Any solution to autom
Read more…I snatched the USB port.Does it exist an alternate solution for uploading a firmware?
Read more…Hi,After cuting the jumper trace in the middle of the APM 2.5 board, this should disable the board’s internal magnetometer and rendering it inert.Unfortunately, it's still alive!With an ohmmeter, there is no connection between the two pads ( the scre
Read more…hello everybody
I just received a Rctimer 433 mHz kit mounted on an APM 2.
The modules are communicating, the led is solid green, I can load the settings but when I want to connect in flight data mode, it does not work, I have an error message (time ou
