Gender
Male
About
Please tell us a bit about your UAV interest
project
Activity Feed
Hiim looking for a qualified uav pilot in london or near london.Please get in contact immediatly for more info.
"Any active meetup / groups from UK ?
more specifically London."
more specifically London."
hi peopleIve been trying to loiter my quadcopter which is a standard 2.5 apm 3drobotics kit with ublox gps. But when I switch to loiter the quadcopter start to hover in a circle with a wide radius. It maintains the altitude and does a pretty…
"Im in stratford. I can bring my arducopter over if thats ok with you. Lets talk more about arranging a time and date ?"
"Hi all. I need some help with my arducopter and the best way I think if I meet someone with experience and get some tips of them. I been trying to get my arducopter in the air for some time now. If anyone is willing to help I can travel anywhere in…"
"Any meetings in london ?"
"Hi
Anyone in london want to help me with my arducopter. Will be appreciated. "
Anyone in london want to help me with my arducopter. Will be appreciated. "
HiI just got some propeller fastners with new replacement propellers. But they look different then the old ones I have. Can anyone guide me to a tutor
HiI had a general knowledge question for the forum.If I wanted to make a autopilot system of my own like ardupilot. How would I go about doing this? Im interested in the hardware side. Like how or where to select a curcuit board, sensors etc.
"Thanks"
"Hi ppl
I have been experimenting with the quadcopter again. As suggested above I moved it side by side while the motors where running and they do respond as oppose to before. I try moving yaw, pitch and roll while the quadcopter is on the ground and…"
I have been experimenting with the quadcopter again. As suggested above I moved it side by side while the motors where running and they do respond as oppose to before. I try moving yaw, pitch and roll while the quadcopter is on the ground and…"
Ive connected my ublox lea-6h to the apm 2.5. But im not getting any responce on mission planner. Do I need to configure it? Can some one help me with this please?What do I need to do?Thanks in advance.
hi thereim trying to calibrate my ESCs on my Quad. all parts bought from 3d robotics im doing the automatic calibration. all goes well all the motors calibrate fine but when i apply the throttle a little bit 3 motors move in sync and one moves abit…
