Gender
Male
About
About Me:
Something about me...
Please tell us a bit about your UAV interest
any UAV
Activity Feed
"Thanks again Darren. Loocking your picture, my mean corncern is that with this scheme, we are feeding also the FTDI chip in the IMU, so we will have two FTDIs chips.... ¿does anybody know if it will be a real problem?"
"
Darren please, could you explain tome how to use the ftdi cable instead USB? I am completely desperate. I will try to take a picture but I am sure I can not repair it."
Darren please, could you explain tome how to use the ftdi cable instead USB? I am completely desperate. I will try to take a picture but I am sure I can not repair it."
After a litlle crash, my USB was detached from the IMU, and probably with no solution because it seems to me that the little cooper paths are also damaged. My question is if I can use the FTDI instead USB? it will work with Arduino software or the…
After a crash with my quad, the IMU Shield USB port has been detached. I think the main pins are not damaged, but the four fixation pins are completely desoldered.I have tried to solder again when I realize that there is no metal in the pad as you…
"Thanks CyberCrash, may be by my bad english but I can´t find the answer in this treatd. Much easier, I bought my GPS before January 2011, so it must to be 1.4 ¿does it right?"
I bought the MediaTek MT3329 GPS from DIYDrones on 11/18/2010. Is there anyway to know what firmware has it? Thanks
"So if I have understood well:
- About my first question, it is better to do the accel calibrationwith APM onboard, even if the quad is not perfectly leveled. that´s right?
- About my second question, you say that there is no problem with the heading…"
- About my first question, it is better to do the accel calibrationwith APM onboard, even if the quad is not perfectly leveled. that´s right?
- About my second question, you say that there is no problem with the heading…"
I will tell you my procedure to calibration: 1. First, I go to CLI accels calibration with the APM/shield placed on a flat surface and I write the values in a paper.2. I mount the APM/shield on my home made QuadCopter.and open the configurator.…
