About

Gender

Male


Location

Grass Valley, CA


About Me:

student in college taking an automated manufacturing course and have always liked r/c but cars and planes could never hold my interest for long but drones that is something else they went from an assignment to addiction and i cant get enough


Please tell us a bit about your UAV interest

I was in awe ever since i saw the first u tube video displaying the ability of unmanned flight I have an aphid reptile 450 and a dji flame wheel 450 and i am in the middle of building a tricopter because of a couple of crashes that left me with some extra motors ,i'm getting into fpv now that i can fly a little better and my interest in the hobble doesnt seem to be slowing down


Hometown:

grass valley


Activity Feed

rodger roth replied to Vai's discussion Copter doesn't lift and draws less current than the maximum current it should actually draw.
"you could check the timing of esc ch 3 end point on radio hope you fix it "
Dec 7, 2016
rodger roth replied to Robert B Von Haden's discussion LidarLite on Pixhawk setting zero range
"status tab under hud look for servorange hard to find alittle"
Oct 9, 2015
rodger roth commented on Doug Walmsley's photo
"hey friend i run dual skywalker 25A 4in1 also but i run a y6 so i dont use all channels , i notice that you mounted yours on bottom have you ever noticed them getting warm /real warm . i also had them mounted between plates so i mounted some comp e…"
Sep 10, 2015
rodger roth replied to Pmarche's discussion Pixhawk and some ESCs with Low KV motors. Pixhawk is not the problem. Problem is related to ESCs, Firmware and fine tuning. in PIXHAWK
"Hows it friend had the same problem beat me up also the solution were two fold i had a bad motor it still calibrated and telemetry was not giving me any help so like you i re did the whole cha cha the bad motor was messing with esc's (skywalker 25A…"
Aug 11, 2015
rodger roth replied to Chandruth's discussion Pixhawk Collision Avoidance
"hello mike i was wondering how you attached the arduino nano to pixhawk so pixhawk and it can communicate because now i am using the uno board and sonar to opperate retractable landing gear , but it runs independant from pixhawk so i have no overide…"
Oct 31, 2014
rodger roth replied to Wilton Beltre's discussion Recommendation for a complete newbie
"okay i dont know how handy you are with a build project but  building one will hepl you understand how to fix it after the crash . because coaxial are great for lifting alot with a smaller frame but it is a smaller frame
i am currently using these…"
Oct 28, 2014