taylor loper's Discussions (4)
Sort by
CLI works fine but none of the other tabs works
I'm currently using the firmware for arducopter 2.9 but it doesn't make a difference since I have the same exact problem with all the firmware. My APM 2.5 will connect to mavlink but in the configuration tab the radio bars just stay empty regardless
Read more…Remzibi OSD 3DR review
The Remzibi OSD 3DR board is hard for me to review since it only worked for about 15 seconds. The board was able to connect to the Remzibi program but while uploading the firmware the board burned out. I haven't tried the Ardupilot Mega MinimOSD Rev.
Read more…Erratic motor behavior
Watch the rear right motor. in the video it's usually on the far right. It starts acting erratic just randomly. I've held a hover for a number of minutes with no problems but then it just goes berserk. It did take a hard hit one time(hard enough to b
Read more…