Propeller Protoboard

I have completed the soldering of all the header pins for servo rx input, servo output, sonar and MESMIC tilt sensor. I also added a temp sensor IC for fun.

Read more…
E-mail me when people leave their comments –

You need to be a member of diydrones to add comments!

Join diydrones

Comments

  • Actually, with my little experience I did the simple thing by just soldering connections and wires to form the actual circuit..nothing fancy. I will upload a picture.
  • 3D Robotics
    Sweet! Any chance you can upload a photo of the back side of that board? I'm trying to learn how to work with proto boards and I've never wirewrapped before. I assume that's what you did?
  • I completed the coding for switch the altitude hold routine with the gear switch so it does not interfere wiht Rx Input. As it turns out it was just a TV out formatting issue and some logic issues in the code. I finally got it to work a couple nights ago, programmed the EEPROM and then bam, my damn prop plug broke, USB connector came apart from the circuit board and Parallax is offering to replace it once they determine how it failed.
This reply was deleted.