Photos

DSC02387

Posted by UAV Pilot on October 5, 2009 at 1:23pm

On the right is the radio reciever for manual rc flight. The GPS module is in the near left. Also pictured is the pitot tube hose. since the motors are on the wings. There is an sd card slot for both programming and logging data

Read more…
Previous
Next
Tags: telemaster uav with attopilot
E-mail me when people leave their comments –
Follow

You need to be a member of diydrones to add comments!

Join diydrones

Comments

  • Moderator
    Gary Mortimer October 6, 2009 at 8:44am
    I should have looked at your other photos, doh! Very impressive.
  • Moderator
    Gary Mortimer October 6, 2009 at 8:30am
    Oh ok, a hybrid that will be fun to watch fly!
  • UAV Pilot October 6, 2009 at 8:26am
    The GPS is in the nose and the motors are out on the wings. With both the motors and the esc's out on the wings that gives me about 12" to the nearest electronics. This also places the GPS, BEC, and Radio RX before the motors. My microwave video downlink and the xbee will all be far aft in the tail. The atto pilot is in the center about 6" from the rx and 12" from the motor and over 24" from the downlinks. Should be a friendly radio environment for all. :)
  • Moderator
    Gary Mortimer October 6, 2009 at 6:50am
    Oh sorry I see its in the nose, you could leave an opening, not worried that the motor will be too noisy for it??
  • Moderator
    Gary Mortimer October 6, 2009 at 6:49am
    Should you not be putting that GPS outside or at least somewhere so you can could the number of satellites that its seeing?? I might be a little worried about shielding there, still balsa won't make much of a difference.
This reply was deleted.