SDC10019

Actually I did not use the belly area for the equipment. The empty area in the front provide enough room. I have succeeded to put an ardupilot with shield, xbee pro 900, a receiver, a switch mode power supply, and 2200 mAh li-po to the front(I will put the photos of inside but the plane is not here at the moment). I do not advice to cut the belly because that will weaken the body and in the case of a crash (I hope there wont) the plane will probably broken from where there is less reinforcement.

You need to be a member of diydrones to add comments!

Join diydrones

Comments

Omer Cayir February 19, 2011 at 1:00pm

Actually I did not use the belly area for the equipment. The empty area in the front provide enough room. I have succeeded to put an ardupilot with shield, xbee pro 900, a receiver, a switch mode power supply, and 2200 mAh li-po to the front(I will put the photos of inside but the plane is not here at the moment). I do not advice to cut the belly because that will weaken the body and in the case of a crash (I hope there wont) the plane will probably broken from where there is less reinforcement.
Rich Weaver February 19, 2011 at 11:25am

Omer -

I'm in the process of building one up too, although I'm running out of room for my UDB and FPV. Have you opened the belly area up to place your equipment in there (that's what I'm thinking of doing)

This reply was deleted.