We use for example CH5,switch C-3positions and switch D-2positions.
1. Transmitter END POINT menu-GEAR -100%
2.SUB-TRIM menu-GEAR -0
3.AUX-CH SELECT menu –CH5-Ls1(Logical switch)
4.LOGIC SW menu.Settings as shown on left.
5.PROG.MIX1-8 menu choose mix 5
6.P.MIX5 page 2/2 settings as shown
7.GYRO SENSE menu settings-CH5 and switch C as shown.
8.GYRO SENSE menu position 2 to ON.
9.C switch up,D switch up and set 68%.Pulse with in this set is 1166µs.
10.C switch middle position,D switch up and set 48%.PW-1264µs.
11.C switch down,D switch up and set 16%.PW-1423µs.
12.P.MIX5 menu tab2/2 turn MIX ON.
13.P.MIX5 tab1/2 C switch down,D switch down and set -(minus)71% at poin5.PW-1554µs.
14.C switch middle,D switch down,set -(minus)76% at point1.PW-1683µs.
15.C switch up,D switch down and set -(minus)71% at point5.PW-1814µs
16.Now P.MIX tab2/2
That's all.There are other ways to do it,no doubt.
You sure you have the same radio? I just went through this process tonight and it worked for me.
I did follow every steps ... but still can't get
How the hell did you figure this out? :-D
yes I have all six working well and this tutorial works if you follow it by the letter
anybody managed to get all 6 modes on 10C ???
my 10C range too narrow .... I followed the instructions above only managed to set 2 mode ....
Thank you -- saved me a lot of pain. I'm still not quite sure what I did, but it works!
FANTASTIC!!! I was nutting my way through the very crappy Futaba manual and nearly driving me to normal!! god forbid that should happen.. Thanks for the great tutorial.