Gender
Male
About
Location
Bandar Utama Selangor
About Me:
Deep Geek
Please tell us a bit about your UAV interest
insanity like a fox terrier
Activity Feed
"Regarding the Analog Airspeed Sensor MPXV7002DP on a Pixhawk and using QgroundcontroleWe cannot get this air speed sensor to work on our VTOL Quad (ranger) plane using the Qgc Quadranger firmware. We have it wired into the ADC 6.6v port and when we…"
"I have also been testing Reach and it seems I am in the same situation that out in the field it works ok sometimes,and then other times it doesn't. Last weekend I updated to the Beta 2.1 and this seem to be a big improvement, however it still has…"
"well done Marco! impressive!"
"Ok I found it, and it doesn't fit on APM1-2.6. (how sad I have these boards and cant be used)"
"Ok I found it, and it doesn't fit on APM1-2.6. (how sad I have these boards and cant be used)"
"Will the QuadPlane firmware from v3.5.1 to v3.6.0 load onto and APM1 or APM-2 hardware? I tried to load them and all seems like it had all loaded ok, but when I look at it under settings in the cli terminal it shows "Init ArduPlane V3.4.0…"
"Will the QuadPlane firmware from v3.5.1 to v3.6.0 load onto and APM1 or APM-2 hardware? I tried to load them and all seems like it had all loaded ok, but when I look at it under settings in the cli terminal it shows "Init ArduPlane V3.4.0…"
"I assume your prices are in AUD on your web site and not USD? Might be wise to make that clear if they are? I am also wondering that even for small areas you recommend 8 units at least. Which is $4000 right? In contrast I am using Emild Reach that…"
"was also my first thought, weight?
I always question the economics, time and resources used and what we are trying to achieve when it comes to making something using my 3D printer.
For sure it makes no sense to make items on a 3D printer that we…"
I always question the economics, time and resources used and what we are trying to achieve when it comes to making something using my 3D printer.
For sure it makes no sense to make items on a 3D printer that we…"
"I was holding my balls what this hahaha.. Variable pitched props could help towards stability and to give yaw. "
"Anyone?"
"what is ROACH?"
"re throttle stick mid position, sprung vs un-sprung?
I wonder what the general consensus is for what people now use and prefer for the throttle stick and whether to have it spring loaded so that it sits in the middle (hover position) compared to…"
I wonder what the general consensus is for what people now use and prefer for the throttle stick and whether to have it spring loaded so that it sits in the middle (hover position) compared to…"
I wonder what the general consensus is for what people now use and prefer for the throttle stick and whether to have it spring loaded so that it sits in the middle (hover position) compared to having it un-sprung as we always used in the past. I can…
"I took an old office swivel chair and removed the back and seat and screwed on a 60cmx50cm board on it to use as a mobile work stand for working on copters. This is also good to tie down your copter to and test the motors on. You can easily see it…"
"Sorry my typo errors. I meant I only get v3.3.3 on stable or after I select beta. Just now I tried APM P2 advanced beta but I still only get 3.3.3 in both stable or beta. I would like to try beta 3.4 but not sure I am game to use the trunked…"
