New Heavy Lift QuadCopter Frame from HH

The Turnigy H.A.L Frame looks to be quite nice....Not sure what Heavy means, but this this is made of aluminum, and at 614grams, is not too heavy, provided the right motors and props are used....I think I will go ahead and order one, and try it out...

Anyway, more information over at HobbyKing: 

http://www.hobbyking.com/hobbyking/store/__22732__Turnigy_H_A_L_Hea...

Views: 5418

Comment by Nick Arsov on May 31, 2012 at 5:48am

Well designed frame! Looks really nice ! Also the price is acceptable. I just wonder how strong the carbon rods are?

Comment by John Stuart on May 31, 2012 at 6:02am

Its just a quad and its in a '+' configuration? Still, price is unbelievable.

Comment by Steve on May 31, 2012 at 11:49am

@John - if you look at the pic of the bottom, it looks like the landing gear can be rotated 45 degrees for X config

Comment by Paolo on June 1, 2012 at 2:20am
Once again, the confirmation that the 3DR frame sucks and is a scandal pay much money an aluminum frame, heavy, with connections for inappropriate engines, not suitable for a photographic camera, it is necessary to raise the feet, in each case with a high cost and poor quality.
Comment by John Moore on June 1, 2012 at 5:39am

Aluminum motor mounts, nice. Im tempted, that dome would look nice with some brigh LEDs behind it...

Comment by Nigel Conliffe on June 1, 2012 at 6:56am

I ordered one (probably should have ordered two or three given my luck in flying).


When it comes, I'll post pictures and editorial comments

Comment by Gerard Valade on June 9, 2012 at 1:21pm

X mount

more difficult to remove the landing gear.

On X configuration, it is difficult to mount the bar, because it hits the nuts, we must place one or more washer under the landing holder.

mounting a 35xx motor

 

Comment by John Moore on June 10, 2012 at 6:06am

Thanks for the pics

Comment by Peter Foster on August 6, 2012 at 12:28pm

Everything rotates through 45 degs for X config quite easily. Not quite sure what those two 2mm cross bars are supposed to do. Swopped the round section arms for some Arducopter square section arms which sit nicely in the orange plastic arm mounts and make life easier for motor and ESC mounting. Just had first flight and after a not too heavy landing, the T joints on one of the landing legs shattered, so not a good start!! Will make them out of aluminium I think.

Comment by Peter Foster on August 9, 2012 at 8:45am

Did a few running repairs to the broken landing gear and then smashed the other side!! In the second picture that Gerard has posted above you can see the pinch bolt arrangement that holds the landing legs - that's only a 2mm screw which is too small to get any sort of pinch, so I've drilled the bracket straight thru 3mm and used a 3mm skt head and locknut - much safer!. Apart from these problems it's a great piece of kit!!

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service