New Image And QGC for Emlid Edge Released

We’ve released the new v1.4 image for Edge and QGroundControl with v3.2.4-edge-2.3 tag!

The new v1.4 image includes a couple of new features that ease your day-to-day work with Edge. The most prominent of those changes are:

  • Camera hotplug support
  • Wi-Fi connection to your own networks rather than being stuck at AP network created on Edge
  • LED statuses are more user-friendly now

QGC v3.2.4-edge-2.3 has got a lot of new features too:

  • New firmware upgrade tab
  • MacOS support is now official
  • New Wi-Fi setup tab

See the full release message, features description, and changelogs on Emlid community forum!

Get started with Edge

With the Edge drone controller launch, we’ve also rolled out extensive documentation for our new autopilot. Check Edge docs for more information.

Besides the docs, we’ve been also working on the tutorial for Edge. It walks you through 5 simple steps of getting started and setting up video streaming. The video covers unpacking, firmware update, basic components set up and ground control station configuration.

Edge Quickstart video will be helpful to everyone who’s just starting with Edge or is considering it for the next project! Setting up video streaming with Edge is easy as ABC, check it yourself!

To learn more about Edge visit http://store.emlid.com/edge.

Best regards,

Emlid team

Views: 1017


Moderator
Comment by Alexandre Mainardi (Nuvem UAV) on April 4, 2018 at 10:10am

well done! 

Comment by Lucas De Marchi on April 6, 2018 at 1:34am
It's a very nice board. I've got mine and I'm assembling a new drone to put it on.

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service