Discussion group for ArduCopter users
Drone flying to non visible point
Hi there,I encountered a problem, while flying in auto mode, with approching to point that was not set by trajectory and is not visible after downloading mission from flight controller by Mission Planner. Does anybody encountered similar problem. The situation is that in the middle flight I stopped the UAV and uploaded new mission and after changing to auto mode it starts to fly in some direction. It goes straight to some point, so I assume it's not mechanical problem. I attached the link to…
Read more…
Comments
Here is a location where you can get some drivers.
http://www.digi.com/support/productdetail?pid=3352
Which module are you using for the xbee? If you go to the site where you bought it, there is usually a link for the drivers.
I need to comunicate the xbee with my andoid device cant find any driver any help?
My first build almost all the bugs iron out Still waiting on my GPS and Power Module. I DUB THE "HOBBYKING SPECIAL!"
HKpilot Mega 2.5
![3692869814?profile=original](https://storage.ning.com/topology/rest/1.0/file/get/3692869814?profile=original)
HK Q450 frame
Q-brain 25 amp esc
3dr radio Telem module
Turnigy multistar 2213 -935 Kv motors
10- 4.5 props
Zippy 4500 Mah compact Lipos "12-15" min flight time
HK batter monitor "may be faulty" lol
springy landing struts !!
Turnigy 9x radio system "stock"
hye!im new here!and im new in multirotor.im using the hexacopter and hope we can share alot of information here!thank you!
Interesting interview with Chris Anderson
@Hillary
I share your thoughts...each time I find a site like this, I go into major absorb mode.
new here,so happy
@Rob,
Ardu may be a shortening of the word Arduino and used to indicate that the original Ardupilot used an Arduino Atmel processor, the 168/328.
Regards,
TCIII ArduRover2 Developer
@Rob J: Stands for Arduino, the family of boards that ArduCopter runs on. See: http://arduino.cc/